24/7 emergency service Monday to Friday, 8am to 5pm Ronkonkoma, NY
Licensed and insured Serving Long Island since 1999 Google reviews
documentation-1

Air Filters

evaporator-and-condenser-coils

Evaporator and Condenser Coils

fan-blades-and-motors

Fan Blades and Motors

condensate-drain-lines

Condensate Drain Lines

ductwork

Ductwork

grilles-and-registers

Grilles and Registers

refrigerant-lines

Refrigerant Lines

outdoor-indoor-units

Outdoor & Indoor Units

thermostat

Thermostat

refrigerant-leaks

Refrigerant Leaks

compressor-issues

Compressor Issues

fan-motor-problems

Fan Motor Problems

thermostat-malfunctions

Thermostat Malfunctions

blower-motor-issues

Blower Motor Issues

capacitor-failures

Capacitor Failures

electrical-problems

Electrical Problems

condenser-coil-problems

Condenser Coil Problems

evaporator-coil-issues

Evaporator Coil Issues

expansion-valve-problems

Expansion Valve Problems

ductwork-issues

Ductwork Issues

heat-exchanger-problems

Heat Exchanger Problems

water-leaks

Water Leaks

control-board-issues

Control Board Issues

airflow-problems

Airflow Problems

Cooling across Long Island since 1999

Air conditioning repair, service and installation on Long Island

Air conditioning that has stopped cooling gets answered on any day of the year, holidays included, with a technician usually at the building inside 90 minutes. If it is not an emergency, start by working out which system you own and which of six services owns the problem.

Out right now? Say on the phone whether the box outside is spinning, humming or silent. That one detail decides what comes off the truck.
631-710-6257
What is in the building

Four ways a Long Island house gets cooled

Air conditioning does not manufacture cold. It picks heat up inside the house and carries it outside, and all four of these are that same trick arranged differently.

Most common here

Central air on the furnace's ducts

A condensing unit outside on a pad, and an evaporator coil sitting on top of the furnace or inside an air handler. It borrows the furnace blower and the ducts that carry heat in winter, so one thermostat usually runs the whole house.

Cools only. Something else makes the heat.

Same hardware, extra valve

A heat pump, which cools and heats

Outdoor unit, indoor coil, refrigerant between them, and a reversing valve that lets the cycle run backwards. In summer it is an air conditioner; in winter it moves heat into the house instead. It can feed ducts or ductless heads.

From the curb it looks like central air.

No ducts needed

Ductless mini splits

One outdoor unit and one or more slim indoor heads high on a wall or ceiling, joined by a line set through a hole about the width of a fist. Every head is its own zone, which is why they turn up in additions, attics and houses with hot water heat.

Many are heat pumps and work in both seasons.

Self contained

Window and through-wall units

The whole machine in one box: compressor, both coils, both fans, split by an internal partition with the hot half hanging outdoors. It cools the room it sits in and no further. The commercial cousin is the packaged terminal unit under a hotel or office window.

Usually the sign a room was never on the system.

Cooling system identifier

Tick what you can actually see

No model number needed. Cooling systems are told apart by what sits outside and how many places the cool air comes from. Tick everything that is true of your house and the board keeps whatever those clues point at.

Vents in floors or ceilings
A slim head high on a wall
A unit in a window or wall sleeve
Two copper lines into the house
The outdoor unit runs in winter
Start over

Four systems still fit

Central air conditioning

Ruled out

The confirmation is the grille: the one that delivers heat in winter delivers cool air in summer, because both seasons share the ducts and the blower.

Most calls on thisA capacitor that will not get the outdoor fan and compressor turning, a condenser coil packed with grass clippings and cottonwood, a starved return or a loaded filter icing the indoor coil, a blocked condensate drain, and a charge that has leaked away.

Faults go to repair. Replacements go to installation, and that list is what maintenance exists to catch first.

A heat pump

Ruled out

It runs on a cold day, and nothing else here does. Whether it feeds ducts or heads is answered by the first two clues, and plenty of houses share the coldest weather with a gas furnace.

Most calls on thisEverything on the central air list, since the cooling half is the same hardware, plus a changeover valve stuck in one mode, and a charge that has drifted far enough to show in the weaker season first.

Cooling faults go to repair. As a heating system it belongs to heat pump installation.

Ductless mini split

Ruled out

Each head has its own control, so there may be no single cooling thermostat anywhere in the house. Several heads can share one outdoor unit, which is why a fault in one room is not always a fault in the system.

Most calls on thisA blower wheel loaded with dust and biofilm until the head runs loud and weak, washable filters left behind the front panel for years, and a gravity drain that blocks and runs down the wall.

Service goes to ductless mini split maintenance; new heads and zones to ductless installation.

Window or through-wall unit

Ruled out

Unplug it and one room stops cooling while the rest of the house carries on. It sits pitched slightly toward the outside so the water it makes runs out instead of in, and its circuit is factory sealed, so a leak usually ends it.

Most calls on thisFilters and a coil that has never been looked behind, a pan overflowing inward because the pitch is wrong, and a room that outgrew what one box in a window can do.

Carrying a room the ducts never reached? Ductless installation is the fixed answer. Packaged terminal units in commercial buildings sit with commercial HVAC.

The hardware

What the parts do, and where each one lives

"The fan outside spins but the humming part never comes on" gets a technician thinking on the drive over. Here is what each piece is called and where it sits.

OutsideThe metal box on the pad, or on the roof
CompressorThe pump at the center of the circuit. It raises the refrigerant's pressure and keeps it moving, and it is what you hear humming under the fan noise. It is the most expensive single part in the system, which is why a compressor failure starts a replacement conversation.
Condenser coilThe rows of fins wrapping the inside of that cabinet. Hot refrigerant gives its heat up to the outdoor air here, and only if air can get through the fins. Grass clippings, cottonwood and a shrub grown in too close matter more than they look like they should.
Condenser fanUnder the grille on top, pulling outdoor air through that coil and throwing it upward. If it stops while the compressor keeps running, the system has nowhere to put the heat.
BetweenThrough the wall or the band joist
The line setTwo copper tubes joining outdoor to indoor. The fat one is wrapped in black foam and carries cool vapor back to the compressor; the thin bare one carries warm liquid out to the coil. That foam is not decoration: bare, the cold line sweats and drips. Fat insulated line, cool vapor back Thin bare line, warm liquid out
Metering deviceA small valve or fixed orifice at the indoor coil, dropping the pressure of the liquid arriving through the thin line. That drop is the moment the refrigerant turns cold, which is why the cold is made indoors.
InsideBasement, attic, closet, or the wall of the room
Evaporator coilAn A-shaped or slab coil sitting on top of the furnace, or inside an air handler in an attic or closet. Room air passes over it and the refrigerant inside takes the heat away. On a ductless system this coil sits in the wall head.
BlowerThe caged fan pulling house air in through the return and pushing it out through the supply ducts. In a central system it is the furnace's own blower working a second season, so a blower fault shows up in both.
FilterIn or beside the air handler, or behind a large return grille in a hallway. It protects the blower and the coil as much as the air. Starve the airflow and the coil can drop below freezing and ice over, and then it stops cooling and starts making water.
Condensate drainThe coil pulls water out of the air as well as heat, and it has to go somewhere: a pan, a trap and a pipe to a drain. Blocked, under an attic air handler, that water goes into the ceiling.
ThermostatThe only part most people ever touch. It calls for cooling and decides how long each run lasts. On ductless the equivalent is a handheld remote per head.
Worth saying once

"It's low on Freon" is usually the wrong sentence

Refrigerant is not fuel and it is not consumed. It goes around a sealed loop absorbing heat in one place and releasing it in another, and the charge that left the factory should still be in the machine years later. An air conditioning system short of refrigerant did not use it up. It leaked.

So a top-up is not a repair, and that distinction is the whole of what air conditioning repair is about: where leaks start on a house system, how a technician finds one, what putting it right involves, and why the charge goes back in by weight.

The island itself

Humidity, salt air, and ductwork drawn for winter

Summer here arrives with the ocean in it. An air conditioning system spends much of its working life pulling water out of the air, and that is the half of the job most people never think about. That is why a system made too large for the house cools badly: it satisfies the thermostat in a short burst, shuts down before the coil has been wet long enough to pull moisture out, and leaves rooms that read the right number and still feel clammy.

Salt air is the second thing. Outdoor coils along the South Shore and out east sit in air carrying salt, and thin aluminum fins and copper tubes corrode faster in it than they do inland. Rinsing a condenser coil is ordinary maintenance anywhere; near the water it is doing two jobs at once.

Then the buildings. Warm air heat came first in most of the housing here, so by the time cooling arrived the ducts were already there and the coil went straight onto the furnace. That is why central air is the default here, and why so many systems inherit a duct layout drawn for a heating job. A duct system sized for heat can be short of return air for cooling, and rooms added later were never on it at all. Those rooms are where the window units and the mini splits end up.

Attics deserve a mention of their own. A great many air handlers and duct runs here live in an unconditioned attic that goes hotter in July than the air outdoors, and every foot of leaky or thinly insulated duct up there is cooling paid for and never delivered. It is the first place to look when a second floor will not keep up with a first.

The honest version

Repair or replace, and how that call gets made

Most cooling faults are repairs, and most of those are repairs on parts that were always meant to be replaced: a capacitor, a contactor, a fan motor, a control board, a blocked drain, a filter. None of that is an argument for a new system, and anyone who turns it into one is selling.

Four things move the conversation the other way, and it usually takes more than one to be a real argument. The failure is the compressor or a coil itself rather than something bolted to the outside of it, because those two are where a repair bill stops looking small beside a new system. The system runs on a refrigerant that is no longer manufactured, so a leak repair depends on what is left in circulation. Repairs have started arriving in a run rather than one at a time. Or the house has changed, and the system was never going to cool the rooms that exist now.

What does not decide it alone is the date on the data plate. A serviced system that is holding its charge is not a replacement candidate because it has had a birthday. Get the call made by an air conditioning contractor who has had the covers off and gauges on it.

Licensed and certified

Technicians factory trained across the major air conditioning brands and holding EPA Section 608 certification for refrigerant handling. Installations are permitted with the town the building sits in and presented for inspection.

Two sets of hours

Quotes, surveys and planned installations run Monday to Friday, 8am to 5pm. Breakdowns are covered every day of the year, holidays included, with a typical on-site response inside 90 minutes across Suffolk and Nassau County.

Since 1999

More than 6,000 completed projects across Suffolk and Nassau County, on single family houses and on commercial buildings, and a good number of customers who have stayed with us fifteen years and more.

This is a great family business and I highly recommend them. I had a issue with a cooling unit which was installed by someone else. I left a message on a Sunday and Larry got back to me within five minutes. Alex was on site as promised the next morning and was able to fix the problem. I think they're great for a few reasons 1) very responsive and arrive when promised, 2) Great communicators, were able to explain the problem, simply and clearly and 3) Prices were reasonable for the quality of service provided. You would be surprised how few firms can deliver these three seemingly simple things. I'm very happy that I have found them and will be using them for my cooling needs going forward.

Bob Knapp
Google review
Questions

Air conditioning questions we get asked most

My system runs all day and the house never quite gets there. Is it broken?

Not necessarily. A system running long and steadily in real heat is doing its job, and long runs are what pull the humidity out of a house here. A change in how it behaves is the thing to call about, because that is a fault and this is not.

Will you work on a system another company installed?

Yes, and a good share of the work here is exactly that. It makes no difference to the diagnosis. The data plate on the cabinet gives the brand, the model and the charge the system should be holding, and that is where the visit starts.

Do you work on ductless mini splits as well as central air?

Yes, both, on homes and on businesses. We install and service central air conditioning and ductless alike. Ductless is covered by its own installation and maintenance services, because the equipment is genuinely different: different indoor hardware, different service work, and zone-by-zone control instead of one thermostat.

It is the middle of a heat wave and there is no cooling. What now?

Switch the system off at the thermostat first, so an indoor coil that has frozen has a chance to thaw before anyone arrives, then call. Emergency AC repair covers what an after-hours call involves.

Next step

Two ways this usually starts

A breakdown, or a plan. If the cooling is out, an outdoor unit is tripping the breaker, or a room has stopped keeping up, call and it gets handled as a breakdown. If it is a replacement, ductless heads for a room that never worked, or a service agreement before the season, ask for a quote and someone comes out and looks at the building.